Inglis Washer Hardware

Agitator Bolt

★★★★★

★★★★★

5 Reviews

This kit contains one screw with rubber gasket and threaded sealant. The screw head is 7/16".

Screw, 8/18 x 3/8 This screw is sold individually.

Washplate Bolt Sold individually.

Screw, 8-16 x 1.000 Sold individually.

Cover Screw Sold individually.

Suspension Spring Retainer

★★★★★

★★★★★

2 Reviews

This is a replacement suspension spring retainer for your washer. The retainer holds the suspension spring in place while the washer is operating. If you notice movement, or an unusual noise or shaking of your washer when it is in use, it could mean that the suspension spring has been disconnected because of a broken or missing spring retainer. You will find the suspension spring retainer at the bottom of the tub assembly. To replace the retainer, use a pair of pliers to disconnect the suspension spring from the chassis mount to relieve the tension. Then, remove the spring from the retaining clip, and remove the retaining clip from the bottom of the washer. Attach the new retaining clip to the bottom of the washer, reattach the spring, and stretch it slightly so it can connect to the chassis. This part is sold individually.

Hose Clamp This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.

Screw

★★★★★

★★★★★

5 Reviews

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.

Screw Metallic screw that is less than an inch long. Does not include the plastic washer.

Gearcase

★★★★★

★★★★★

3 Reviews

This is used in your direct drive washer that has a neutral drain.