Models > DLEX3370W

DLEX3370W ((ABWEEUS)) LG Dryer - Overview

Sections of the DLEX3370W

[Viewing 4 of 4]
Keep searches simple, eg. "belt" or "pump".
Dryer Lint Filter – Part Number: ADQ56656401
Dryer Lint Filter
★★★★★
★★★★★
(22)
PartSelect #: PS3531962
Manufacturer #: ADQ56656401
The Dryer's Lint Filter is used to collect lint during the dryer cycle as it passes through the dryer vent, in order to prevent damage to the machine. This manufacturer-approved part comes in gray, me...
$69.23
  In Stock
PARTS ASSEMBLY, SVC (2 Pack) – Part Number: AGM75510755
PARTS ASSEMBLY, SVC (2 Pack)
★★★★★
★★★★★
(6)
PartSelect #: PS16763594
Manufacturer #: AGM75510755
The drum roller for your dryer holds the drum in place while the drum turns on the support wheels. The drum roller is round with a bearing in the middle and measures approximately 3 inches in diameter...
$163.39
  In Stock
Lint Screen Housing – Part Number: MCK49049101
Lint Screen Housing
★★★★★
★★★★★
(1)
PartSelect #: PS3534930
Manufacturer #: MCK49049101
This is an authentic dryer lint filter cover sourced directly from the manufacturer. It protects the more delicate lint filter in your dryer, so that it doesn’t get damaged and lint can’t mix in with ...
$74.40
  In Stock
Moisture Sensor – Part Number: 6500EL3001A
Moisture Sensor
★★★★★
★★★★★
(2)
PartSelect #: PS3529161
Manufacturer #: 6500EL3001A
$28.41
  In Stock
Dryer Drum Belt – Part Number: 4400EL2001F
Dryer Drum Belt
★★★★★
★★★★★
(3)
PartSelect #: PS11705916
Manufacturer #: 4400EL2001F
This belt helps rotate from the drive motor to the drum.
$81.30
  In Stock
Filter Guide – Part Number: MEA49050001
Filter Guide
PartSelect #: PS3535278
Manufacturer #: MEA49050001
This is a replacement lint screen guide for your dryer. The lint screen guide attaches to the front bulkhead and supports the lint screen. If your lint screen will not stay in place, or if you are not...
$54.54
  In Stock
High Limit Thermostat and Thermistor Kit – Part Number: AGM30045804
High Limit Thermostat and Thermistor Kit
PartSelect #: PS16878105
Manufacturer #: AGM30045804
This thermistor is used in dryer
$114.11
  In Stock
Dryer Thermistor – Part Number: 6323EL2001B
Dryer Thermistor
★★★★★
★★★★★
(1)
PartSelect #: PS3529026
Manufacturer #: 6323EL2001B
This thermistor is used in dryer
$43.85
  In Stock
Felt Seal – Part Number: 4036EL3001A
Felt Seal
★★★★★
★★★★★
(1)
PartSelect #: PS3522851
Manufacturer #: 4036EL3001A
$61.79
  In Stock
Blower Thermostat – Part Number: 6931EL3002M
Blower Thermostat
★★★★★
★★★★★
(2)
PartSelect #: PS8747887
Manufacturer #: 6931EL3002M
$58.57
  In Stock
Side Venting Kit – Part Number: 3911EZ9131X
Side Venting Kit
★★★★★
★★★★★
(1)
PartSelect #: PS3575086
Manufacturer #: 3911EZ9131X
$248.08
  In Stock
Leg – Part Number: 4778EL3001B
Leg
PartSelect #: PS3523560
Manufacturer #: 4778EL3001B
This plastic adjustable dryer leg is used to support the weight and adjust the height of your dryer to keep it level. To install the leg, tip the dryer back and screw it into the bottom of your dryer ...
$13.95
  In Stock

Questions And Answers for DLEX3370W

Ask our experts a question about this model and we'll get back to you as soon as possible!

1 question answered by our experts.
  • 1
Sort by:
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Paul
March 14, 2024
Dryer doesn't get clothes completely dry.
For model number DLEX3370W
PartSelect logo
Hello Paul, thank you for your question. It can be that it is not heating properly this is likely due to a blockage to the dryer's airflow or a build up on your air filter. Also, you may want to check the Moisture Sensor PS352916. We hope this helps.

Was this helpful?
Thank you for voting!
  • 1

Common Symptoms of the DLEX3370W

[Viewing 6 of 6]
Noisy
Fixed by
these parts
Fixing Fixing Fixing
Show All
Marks left on clothes
Fixed by
these parts
Fixing Fixing Fixing
Show All
Door won’t close
Fixed by
these parts
Fixing Fixing Fixing
Show All
Not Heating
Fixed by
these parts
Fixing Fixing Fixing
Show All
Leaking
Fixed by
these parts
Fixing
Show All
Drum Not Spinning
Fixed by
these parts
Fixing
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Dryer making a thumping and squealing noise when running
Had to replace front drum support rollers. Removed screws underneath top in back that held bracket that keeps top in place. Slid top towards rear and lifted up. Removed 4 screws that hold plastic front panel in place (inside..2 on each corner) Unplugged front panel electric plugs to remove panel. Opened door..removed 2 screws at bottom of door opening. Removed screws on top of front panel. Unplugged door switch plug. Removed front panel. Removed right front roller with 9/16th wrench for nut. Adjustable for back of stud. Lifted up on drum to get roller out. Reversed to install. Left roller a bit harder to get to stud. Removed and installed same as right side. Did not attempt to replace rear rollers. Have them if needed but very much more involved to replace.
Parts Used:
PARTS ASSEMBLY, SVC (2 Pack)
  • Mark from WAVERLY, OH
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers, Wrench (Adjustable), Wrench set
87 of 108 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Screeching during operation
Found disassembly video and watched several times. Suspected that one of the drum wheels had seized up. Found extreme volume of lint and hair inside unit as well as a dryer sheet melted on top of heating unit. Front left drum wheel was worn down from lint and hair jamming its movement. Video made it easy, not a really complicated piece of machinery. Replaced all 4 wheels due to normal wear on other three. Wanted to be sure drum evenly balanced on all 4. Parts came quickly and were easy to install. My sister and I did this together. Would not recommend doing it alone. Took time to vac and wipe down entire unit. Now it runs so quiet we have to look to see if it is operating. Got a brand new machine out of it, saved a couple of hundred dollars in repair bills, and found 11 cents inside the machine. For your own piece of mind, if you have had your dryer for several years, you need to open it up and clean it out. Its not hard... added note, we are both in our 60's... so if we can do it so can you.... Such a feeling of accomplishment, can't buy that in a store....
Parts Used:
PARTS ASSEMBLY, SVC (2 Pack)
  • CAROL from NAMPA, ID
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    More than 2 hours
  • Tools:
    Pliers, Screw drivers
36 of 49 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Filter parts chipped - replaced
Removed existing parts using screwdriver, positioned new parts in dryer and re-inserted screws, tightened - done. Piece of cake, even for someone who cannot saw a straight line with a chop saw.
Parts Used:
Filter Guide Lint Screen Housing Dryer Lint Filter
  • David from Annapolis, MD
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
49 of 89 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!