This ceramic microwave fuse is just over an inch in length. It is white in the center, and metal on both ends. This is a 20-amp fuse, and is used to power your microwave. If the touch pad on the micro...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
March 7, 2023
I have a under counter GE Microwave with a vent door which opens once the blower start. The cam motor which opens the door no longer rotates when the vent is turned off to close the door. The cam motor will work if I manually open the door to reduce the resistance. The motor assembly is marked M2CK59ZT69-H. Do you have a replacement. SN VD968213S
For model number JVM1860SF001
Hi Tony, thank you for the question. According to our research, the part you are looking for is the drive motor, part number PS237842. However, before replacing the drive motor, we would suggest you check the louver micro-switch, part number PS237035, which detects the position of the louver and starts the motor to open or close the louver for proper ventilation. If the problem persists, then you may need to replace the whole louver assembly, part number PS229561. We hope this helps!
Turned out the issue was easily solved by replacing a single, inexpensive fuse.
First off, UNPLUG THE MICROWAVE.
The fuse is located under the plastic grill at the top of the microwave. It's held on by two screws. Once you've removed the screws and taken off the plastic grill, you go to the right side of the microwave and remove another screw that holds a small metal grill in place. Removing the small metal grill is probably the toughest part of this repair. You kind of have to rock it back and forth a bit to get it to release. Once that's off, you can get to the fuse. I removed the burnt out one with a pair of needle nose pliers. I also put a small piece of cardboard under the fuse when I did this so I didn't accidentally drop it into the innards of the microwave. I did the same thing when I replaced the new fuse. I then plugged the appliance back in and made sure it worked. Once that was confirmed, I replaced both grills.
First I unscrewed the screws that were holding the panel underneath. Then I removed the panel and removed the screws that held the turntable motor in place. Then replaced the old motor with the new and screwed everything back into place.