White Dishrack Roller

I opened the end stop of the rack, replaced the roller, and put the end stop back on. I can't believe I paid the repairman the last time $125????? An he put in a regular screw that rusted and broke the roller. Took me 3 minutes! Thanks

I watched the installlation video found on the wedsite and followed his directions.

Once I figured out how to get the endcap off the roller track (allow several minutes, because it was designed by some dork), I slipped the old roller off the track, put the new roller on, and clipped it to the rack. Then I put the track cap back on (really easy once you've figured out how to get it off) and it was good as new.

As for how the cap comes off, it's difficult to describe. But it may help you to know that the cap, despite what it looks like at first, is actually surprisingly long and folded on top of itself. Pulling it directly out doesn't work; you have to unfold it before there's any chance of getting it out.

snapped on new roller and job done

Removed the old dishrack shelf by taking off the end caps. A screw driver was used to release the plastic end caps. The old dishrack shelf is now able to just roll out and the new shelf is rolled in and the old end caps replaced. Quick and easy plus it makes the dish machine look new. The new silverware basket requires no tools just replace the old one.

The sketches on PartSelect.com were very-very helpful, in picking up the parts to order and also while fixing the parts.

For oven range. First I removed the two screws that hold the flat top in place and lifted the flat top. I then unscrewed the two screws that holds the element kit. Disconnected the three wires, and replaced the broken element with the new one. All done.

For dishwasher, just snapped the parts in and all set.

First, removed end cap in steel sliding upper rail, second, removed broken roller, third, attached new roller, you can look at other rollers to see how it goes on, fourth, feed new roller into track, replace end cap. Takes less than 10 min, saved 85. 00 Bucks.

Took off old part. Modified new roller w'knife. Found a nut and bolt in scrap pile. Attached.

I brought the rack to my computer and pulled up your diagram. It was relatively easy to follow the diagram to install the parts. They didn't need any tools, just snap them in place. Wife factor, very high, she can now use the dishwasher again.

R & R parts....good as new.