Water Level Switch

To replace the water level switch is easy, remove the three screws in the rear, slide top back a couple of inches, lift cover off. Rear upper right corner is the switch. Remove small hose to switch, twist switch 90* and pull out, disconnect two connectors, reverse procedure to install new switch. This did not fix the code problem tho. To get to the pump filter is not very difficult but time consuming. Disconnect the power cord. Remove the soap dispenser, then the two screws behind it, then two screws for the front control panel, then four screws on the bottom of the front cover, back out but leave in the three screws on top of front cover, two screws holding the door lock and switch, careful with that, wires are short and difficult to plug back in, remove water spout from drum seal , lift out the bottom of front cover, the seal holds it in, reach in lying on the floor, the filter is in the center, make sure the washer is empty or water will run out, unscrew filter. I found a fabric eyeglass holder and a $1.94 in coin. This tells me the seal to drum is to far away. Reverse procedure to put back together. I will never buy another front loading Washer again. They don't appear to get enough water to really do a good wash job no matter what cycle you use. If you should pull the seal off close to the drum , it's difficult to fasten back on again.