Hinge Bushing
$10.25
Special Order
PartSelect Number
PS271111
Manufacturer Part Number
WH1X2741
Manufactured by
GE
Troubleshooting
This part works with the following products:
Washer.
This part works with the following products:
General Electric, Hotpoint.
Part# WH1X2741 replaces these:
AP2044908, 277947, WH01X2741
Customer Repair Stories
Average Repair Rating: 2.0 / 5.0, 1 reviews.
What's this?
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
unit would not agitate or spin
I checked the motor,it was bad I was pulling to 20 amps too much. The washer was still not working and the motor was bad so I checked the lid switch for continuity. The switch was a magnet type so with the lid down you should have continuity. In other words, a closed circuit. When the lid is opened, you should have a open circuit, Which would show no continuity. An open circuit means a break in the circuit. To change hinge bushings, raise lid, remove the screws on the outside of the lid, remove hinge, remove lid, insert new hinge bushings, place hinge through lid into bushings, and then put the screws back into the lid. If you followed these steps you should be done.
Other Parts Used:
-
Michael from Ballwin, MO
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:More than 2 hours
-
Tools:Nutdriver, Screw drivers, Socket set, Wrench set
3 of 12 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
- < Prev
- 1
- Next >
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Ron
September 10, 2017
It fills up when it goes from wash to rinse it quits and starts humming unhealthily washer turns off.
For model number GTWN4250D1WS
Hi Ron,
Thank you for your inquiry. You may want to check your lid switch to see if it is working correctly. If this part is malfunctioning then it could be that the machine is reading that the door is open and so it will not go into the spin cycle. I hope this helps. Good luck with your repair.
Was this helpful?
Thank you for voting!
Related Parts:
- < Prev
- 1
- Next >
Related Parts
Model Cross Reference
This part works with the following models:
PartSelect Number: PS271111
Manufacturer Part Number: WH1X2741
Manufacturer Part Number: WH1X2741
Brand
Model Number
Description