Product Description
Drive Motor and Inverter Assembly Specifications
In the spin cycle the drive motor rotates the spin basket. When its in the agitation cycle it turns the gearcase shaft.
Note: Please unplug the washer before installation.
How Buying OEM Parts Can Save You Time and Money
Part Videos
Replacing your General Electric Washer Drive Motor and Inverter Assembly
Troubleshooting
This part works with the following products:
Washer.
This part works with the following products:
General Electric, Hotpoint.
Part# WH20X10093 replaces these:
WH20X10030, WH20X10035, WH20X10043, WH20X10051, WH20X10057, WH20X10082, WH20X10092
Customer Reviews
Filter By Rating:
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
Dwain W - August 19, 2020
Verified Purchase
Shipping was very fast.
Exact replacement motor, installed in minutes and the washing machine works great again.
Mario F - November 13, 2018
Verified Purchase
Fast Delivery and easy to replace
Working fine
- < Prev
- 1
- Next >
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
- < Prev
- 1
- 2
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Mindy Burns
September 20, 2017
We had to replace the motor on our GE washer. It now sounds very loud when spinning, like an airplane wanting to take off. I never notice it before it was replaced. I read through the manual and it said it had a fast speed motor. I noticed sporadic issues after we got it until the motor went out. Is this a normal sound for a fast spin washing machine? Thank you.
For model number GTWN2800D1WW
Hi Mindy,
Thank you for your inquiry. When a washer is in good working order you normally do not hear the motor. It is possible that the new motor is defective. Is the washer also shaking and moving?
5 people found this helpful.
Was this helpful?
Thank you for voting!
Jamie
July 9, 2019
I have a WHDRR418G1WW washer. It is filling and draining with water, but not agitating or spinning. By the motor there is a Green light that flashes four times and then is off for about 6 seconds. What does that error code mean? The drive belt is clearly worn, but it is still turning the drum when I turn it by hand.
For model number WHDRR418G1WW
Hello Jamie, Thank you for the question. You can try to reset the computer boards. You do this by unplugging appliance and wait for 30 secs. Plug in machine and open and fully close the lid at 5 times. This resets computer boards, which can get messed up by power surges. The belt can also be the issue as it is not gripping and turning the drum properly. I suggest also having it replaced. Hope this helps!
2 people found this helpful.
Was this helpful?
Thank you for voting!
Greg
February 7, 2020
Folks; we had a power outage then a power surge. Must have damaged pc board, etc. Will your motor work on our machine? Everything looks just the same but, numbers don't match model #? Thanks
For model number GTWN3000M1WS
Hi Greg. This part is compatible with model GTWN3000M1WS. Thank you for your question and good luck with your repair.
2 people found this helpful.
Was this helpful?
Thank you for voting!
Charles
September 6, 2023
how can i check motor b4 replacing?to be sure it is bad?
For model number htwp1200dww
Hello Charles, thank you for the question. We have linked a video that might help you to check the drive motor. The drive motor shown in the video may be different from yours, but it will give you a general idea of how to check the drive motor. We hope that helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Scott
August 5, 2018
My motor flashes fault #7 check mag and door switch, i tested the switch ok, tried to reset motor and that didn't work, machine will fill with water but will not run due to fault 7, any suggestions?
For model number glwn2800d2ws
Hello Scott, thank you for your question. The inverter control expects to see the lid switch open after every cycle. When 4 cycles are completed without the lid switch opening, the inverter control assumes that the lid switch is defective. If the lid switch was tested and is functioning as it should the error is probably in regards to the motor and inverter, which should then be replaced. I hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Gary
September 25, 2017
My po24 says needs to replace motor software does that come separate from the motor assembly
For model number GTWN3000M1WS
Hi Gary,
Thank you for your question. Software would mean the programming inside of your motor control. I do not believe that would be something that you could buy. You may need to replace your part or contact a technician to service your appliance. Good luck with your repair.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Mohammed
January 5, 2018
Motor drive not run
For model number WH20X10093
Hello Mohammed, Thank you for your inquiry. You can test the motor with a multi-meter. If you are unfamiliar with how a multi-meter functions, there are YouTube videos available to assist you. Hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Bill
April 28, 2018
On the circuit board there is a flashing light does this mean motor is bad ?
For model number HSWP1000M3WW
Hi Bill, Thank you for the question. Please resubmit a new question with what light is flashing and we will be able to tell you what the flashing light means. Look forward to hearing from you!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Conrado
April 29, 2018
How do I troubleshoot if the motor is bad. I already take it out of the washing machine. The technician told me I have to replace it. I want to be sure he is correct.
For model number hswp1000m4ww
Hi Conrado, Thank you for the question. I suggest testing the switch in the motor with a multi meter to check for continuity. Hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Bill
April 30, 2018
Red light flashing on top of motor, under circuit board,does this mean motor is bad?
For model number HSWP1000M3WW
Hi Bill, Thank you for the question. It will depend on how the light is flashing. If it flashes one second on and one second off, then there is no fault with the motor. Hope this helps!
Was this helpful?
Thank you for voting!
- < Prev
- 1
- 2
- Next >
Related Parts
Model Cross Reference
This part works with the following models:
PartSelect Number: PS8746234
Manufacturer Part Number: WH20X10093
Manufacturer Part Number: WH20X10093
Brand
Model Number
Description